This is the set-up sheet that I recommend before. The only change to it I made was I went. Im going to keep working on the TC4 setup and maybe try running 19T Rubber Class and keep my XRay for Stock Class (Foams). Sudeep Sahir Serials there. Thanks for all the help guys. This is just an example. I figured out what the problem was. Thank you for purchasing this Team Associated product. In the manual.! There is a 1:1 hardware foldout page in the back of the manual. To check the size of a part, line up your hardare with the correct drawing until you find. Remember, each adjustment has a purpose, so copy everything from the setup sheet and then.

Team Associated just replied to my problem with this: Make sure that your servo is not over-steering the steering block. This would cause a slight binding in the driveline as the CVDs are at an extreme angle. Now how do I do this? By turning down my epa on my controller? Turn down your dual rate on the radio.

I have my epa set to full 125% Left and Right, but my dual rate (set to my thumb button, so I can change it on the fly.) is set to 60% on a open track it is less then this, on a tight track I have had it as high as 74%. I would like to get everyones opinion on this. I have been looking at setup sheets and I have an issue with how the arm spacing is noted on the sheet. For this sheet as an example: Does the setup show the front arm arm all the way to the front of the car or all the way to the rear.

Also is the Rear arm all the way to the front or all the way rear? For the front suspension there is the 'Arm Spacing' section which have four dots and 'Back' at the top and 'Fwd' at the bottom. Lets say that the third dot from the top is left blank. That is where the arm is supposed to go with 2 shims in front of the arm and 1 behind, right?

The most confusing part is that it says 'Back' and 'Fwd' and for the rear it has 'fwd' at the top of the box and 'back' at the bottom. Wouldn't it be more clear to change the 'Back, Fwd' with 'front of arm' and 'Rear of arm'. Whats everyone think. Hey every body im brand new to this site. Ce9500b1 Driver Windows 7 X64 here. Not new to the game though. I just bought a AE tc4 and this is the largest and best forum for this car.

This will be my first electric touring car. I used to drive nitro touring cars like hpi rs3 and an hpi nitro MT racer. I currently have a duratrax evader ST pro modded heavily very fast. Brushless and all. Anyway just wanted to tell you all that i plan to race this car.

I plan to race in the 19 t limit class. I do have a few questions. 1- stock out of the box with a 19t motor can this car win races? 2- do i have to do any neccassary modding before entering a race? Does anyone have any suggestions. 3- what 19 t motor do you guys like.